Warm air blower manufacturers supply industrial warm air blowers

There are various heating methods currently available, including underfloor heating, radiant heating, warm air, convection, and so on. There are also many energy options, including traditional coal-fired heating, widespread electric heating, and the current rise of fuel gas heating. Among various heating methods, air heating is relatively good, and industrial warm air fans are the common air heating method. The warm air blower manufacturer supplies industrial warm air blowers, which can provide clean and dry hot air to heat the entire space with uniform temperature.

Characteristics of industrial warm air blower:

1. Temperature continuously adjustable

2. Dual automatic overheating protection, manual restart device

3. There are warm air start and automatic cooling shutdown devices. The electric heating tube will automatically start the fan only after preheating to a certain temperature, ensuring that warm air is immediately available; After stopping the heating, the fan automatically runs for a period of time to ensure that the entire machine cools down to the appropriate temperature before automatically stopping, enhancing the stability of the equipment and the convenience of operation. High quality components and materials are used to ensure product quality

5. The internal wires are made of high-temperature resistant silicone wire to extend their service life

6. Adopt imported connectors to ensure the reliability and stability of electrical connections

7. The electric heating tube is made of 304 stainless steel, and the internal filler is imported high-temperature crystallization, ensuring the stability of heating and extending the life of heating components.

8. The structural design is reasonable and beautiful, the bracket is stable and beautiful, and comes with wall hooks for easy placement, hanging, and lifting. The rear anti bird net cover design can increase air intake efficiency, facilitate motor heat dissipation, and save corresponding space.

The steps for supplying and using the warm air blower manufacturer are as follows:

1、 Firstly, prepare the corresponding square cable to connect the power cord of the heater (please connect the power cord with a grounding wire)

2、 To make the surface of the heater sturdy, it should be kept away from damp environments and flammable materials.

3、 Connect the power supply of the heater.

4、 Set the temperature regulator knob to the top and let the heater run at full power.

5、 The heater will connect to the heating selection device.

6、 The heater will automatically start and stop to maintain a constant indoor temperature.

7、 Once the room temperature reaches the required level, the heating element will stop working, but the fan will continue to operate. Once the temperature drops, the heating element will continue to heat up.

8、 Before turning off the heater, please turn on the thermostat OFF and turn the knob to turn off the heater, allowing it to cool down within 2 minutes.

9、 The temperature regulator is cut off for extended time. If you forget to turn off the temperature regulator in the OFF position before turning off the heater, the temperature regulator will be cut off and the fan will continue to work when the temperature of the heater approaches 50 ℃. When the temperature drops to around 40 ℃, the temperature regulator and fan will stop working, and the heater will cool down.